BM2 BIEMMEDUE COMBY Manual Del Usuario página 11

IMPORTANT - The customer is responsible for
verifying that original parts only are used when
carrying out repairs. The use of non-original spare
parts could jeopardise the safety of the machine.
When ordering spare parts, specify the model and serial number of
the machine and the reference number of the component in the
spare parts book and quantity.
9 Storing the machine
9.1 Storing the machine
If the machine is not used for long periods, protect exposed parts
(not protected by paint, surface treatment or plastic) with protective
rust prevention oils. If the machine is not to be used for particularly
long periods, you should also clean it thoroughly. After performing
these operations, seal the machine inside an opaque black
multilayer nylon bag together with a suitable drying agent (silica gel).
10 Disposal
10.1 Disposing of the machine
For countries in the European Union, before disposal, check the
technical data label on the machine: if the symbol shown on the side
is present, it means that the disposal is subject to the European
directive 2012/19/UE regarding Waste Electrical and Electronic
Equipment, WAEE, and to current national norms. Therefore, the
regulations and guidelines of the local system for the disposal of
electrical and electronic devices must be strictly followed.
11 Table of regular maintenance
OPERATION
Check the functioning of all
controls
Check connector gaskets
Check oil level in the pump
12 Troubleshooting
The table below gives the most common problems which
may arise during normal use of the high pressure washer.
These problems are easy to resolve with operations
classified as routine maintenance If the problem is not
present in the following table or cannot be eliminated
following the instructions here, contact customer service.
X
X
X X
PROBLEM CAUSE
The machine does Fuel is absent or
not start up insufficient
Other
Irregular engine Examine
operation carefully before
any attempt
Inadequate Nozzle
pressure or distorted
Valve
worn
Vibrations and/or The
abnormal water sucking in air
discharge
Air in the hoses
Pump
worn
Suction delivery
valves blocked
Pump noisy Bearings worn
"White" oil Seepage
water into the oil
(emulsion)
Water leaks Gaskets
pistons worn
REMEDY
Check the level and
fill if necessary
Refer to engine
manual use
maintenance
Contact customer
service
blocked Clean or replace
dirty or Contact customer
service
pump is Check water supply
connectors
Vent the air
disconnecting
hose
gaskets Contact customer
service
Unscrew valve caps,
remove and clean
(ideally contact
customer service)
Contact customer
service
of Have the seal pack
replaced
customer service
and/or Have the seal pack
replaced
customer service
and
by
the
by
by