A/F Reset; Stop/Start Reset; Nox Sensor Reset; Adblue Reset (Diesel Engine Exhaust Gas Filter) - Thinkcar THINKSCAN Max Manual De Instrucciones

THINKSCAN Max
www.mythinkcar.com

5.2.20 A/F Reset

This function is applied to set or learn Air/Fuel ratio parameters.

5.2.21 Stop/Start Reset

This function is used to open or close the automatic start-stop function via setting the
hidden function in ECU (provided that the vehicle has a hidden function and supported by
hardware).

5.2.22 NOx Sensor Reset

NOx sensor is a sensor used to detect the content of nitrogen oxides (NOx) in engine
exhaust. If the NOx fault is re-initialized and the NOx catalytic converter is replaced, it is
necessary to reset the catalytic converter learned value stored in the engine ECU.

5.2.23 AdBlue Reset (Diesel Engine Exhaust Gas Filter)

After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset
operation is required.

3.5.24 Seat Calibration

This function is applied to match the seats with memory function that are replaced and
repaired.

5.2.25 Coolant Bleeding

Use this function to activate the electronic water pump before venting the cooling system.

5.2.26 Tyre Reset

This function is used to set the size parameters of the modifi ed or replaced tire.

5.2.27 Windows Calibration

This feature is designed to perform door window matching to recover ECU initial memory,
and recover the automatic ascending and descending function of power window.

5.2.28 Language Change

This function is used to change the system language of the vehicle central control panel.

5.3 ThinkFile

It is used to record and establish the file of the diagnosed vehicles. The file is created
based on the vehicle VIN and check time, including all diagnostic-related data such as
25