Thinkcar THINKSCAN Max Manual De Instrucciones página 9

www.mythinkcar.com
Systems
P=Powertrai
B=Body
C=Chassis
U=Network
0 - Generic(SAE)
1 - Manufacturer Specifi c
2 - Generic ('P"Codes) and
Manufacturer
Specifi c ("B","C"and
"U"Codes)
3 - Includes both Generic
and Manufacturer
Specifi c Codes
2.3 Data Link Connector (DLC) Location
The DLC (Data Link Connector or Diagnostic Link Connector) is typically a 16pin connector
where diagnostic code readers interface with the vehicle's onboard computer. The DLC is
usually located 12 inches from the center of the instrument panel (dash), under or around
the driver's side for most vehicles. If Data Link Connector is not located under dashboard,
a label should be there telling location. For some Asian and European vehicles, the DLC
is located behind the ashtray and the ashtray must be removed to access the connector. If
the DLC cannot be found, refer to the vehicle's service manual for the location.
DTC Example
P0201
Code Type
THINKSCAN Max
ldentifies what section of the
system is malfunctioning
Sub-systems
Identifies the system where the
problem is located."P"Code systems
are listed below."B","C"and"U"Code
system will vary.
0 - Fuel and air metering; Auxiliary
emlssion controls
1 - Fuel and air metering
2 - Fuel and air metering (injector
circuit malfunction only)
3 - Ignition system or misfi re
4 - Auxiliary emission control system
5 - Vehicle speed control and idl
control system
6 - Computer output circuits
7 - Transmission
8 - Transmission
9 - Transmission
A - Hybrid Propulsion
B - Hybrid Propulsion
C - Hybrid Propulsion
7