Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
WARNING!
Electric shock hazard
Disconnect the mains power supply before installing the dishwasher. Failure to do so may
result in death or electric shock. The electrical and plumbing installation must be carried
out by professional and qualified personnel.
On grid connection
For personal safety reasons:
•
Do not use an extension cord or adapter plug with this product.
•
Do not, under any circumstances, cut or remove the grounding wire from the power cord.
Electrical requirements
Refer to the specification label for voltage rating and connect the dishwasher to the appropriate power
source. Use a recommended 10A / 13A / 16A fuse, timer fuse or circuit breaker and provide a separate
circuit for this product only.
Electrical connection
Make sure that the voltage and frequency of the current correspond to those on the specification label.
Only connect the plug to a properly grounded outlet. If the socket to which the product is to be
connected is not suitable for the plug, replace the plug, rather than using an adapter or similar, as this
may result in overheating and burns.
Water and drainage connections
Cold water inlet connection
Connect the cold water supply hose to a 3/4 (inch)
threaded connector and make sure it is securely fastened
in place. If the water pipes are new or have not been used
for a long period of time, let the water run to ensure that it
is clean. This consideration is necessary to avoid the risk
of the water inlet becoming blocked and damaging the
product.
Information on the safety supply hose
The safety supply hose consists of a double layer. This system ensures operation by blocking the water
flow in case the supply hose ruptures and when the air gap between the supply hose and the outer
corrugated hose fills with water.
WARNING! If the hose that connects to the sink is installed on the same water line as the
dishwasher, it may burst. If your sink has one, it is recommended to disconnect the hose and plug
the hole.
How to connect the safety supply hose
1. Completely remove the safety supply hoses from the storage compartment at the rear of the
dishwasher.
2. Tighten the nuts on the safety supply hose to the 3/4 inch threaded spanner.
3. Fully open the faucet before starting the dishwasher.
How to disconnect the safety supply hose
Turn off the water supply and unscrew the safety supply hose from the tap.
Standard supply hose
44
English
Safety supply hose
infiniton.es
Publicidad
