Infiniton DIW-BB681 Manual De Instrucciones página 47

Installation
Step 4. Installing the dishwasher
Note: Refer to the installation steps specified in the installation drawings below.
1. Place the condensation film under the work surface of the furniture. Make sure that the condensation
film is flush with the edge of the work surface (Step 2).
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cable.
5. Move the dishwasher into position (Step 4).
6. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by turning the
star screw located in the centre of the dishwasher base with a Phillips screwdriver. To adjust the front
feet, use a flat screwdriver and turn the front feet until the dishwasher is level (Step 5 to Step 6).
7. Install the cabinet door on the outer door of the dishwasher. (Step 7 to Step 10)
8. Adjust the door spring tension using an Allen spanner by turning clockwise to tighten the left and right
door springs. Failure to do so may damage your dishwasher. (Step 11)
9. The dishwasher should be secured in place. Secure the side with screws.
Step 5. Leveling the dishwasher
Note: The dishwasher must be level for proper operation.
1. Place a spirit level on the door and on the shelf rail inside the tub, as shown, to check that the
dishwasher is level.
2. Level the dishwasher by adjusting the three leveling feet individually.
3. When levelling the dishwasher, take care that it does not tip over.
Note: The maximum height of the adjustable feet shall be 50 mm.
9
Check level
front to back
Check level
side to side
UP
DOWN
49
English
infiniton.es