Keysight U1271A Guia Del Usuario página 24

1 Introduction
1 Open the battery cover. Lift the tilt stand and loosen the screws with a
2 Insert the battery. Observe the proper battery polarity. The terminal ends of
3 Close the battery cover. Place the battery cover back in its original position
Figure 1-1
The battery level indicator in the lower left-hand corner of the display indicates
the relative condition of the batteries.
levels the indicator represents.
24
suitable Phillips screwdriver and remove the battery cover as shown in
Figure 1-1.
each battery are indicated inside the battery compartment.
and tighten the screws.
1
3
Installing the batteries
2
Table 1-1 describes the various battery
Keysight U1271A/U1272A User's Guide