STERWINS UP20 Instrucciones De Montaje página 207

When the log is supported on one end, cut 1/3 the diameter from the underside (under buck).
Then make the finished cut by over bucking to meet the first cut. When the log is supported on
bath ends, cut 1/3 the diameter from the top (over buck). Then make the finished cut by under
bucking the lower 2/3 to meet the first cut. When "cutting through", to maintain complete
control release the cutting pressure near the end of the cut without relaxing your grip on the
product handles. Always stop the engine before moving from tree to tree. If the wood diameter
is large enough for you to insert a soft bucking wedge without touching the chain, you should
use the wedge to hold the cut open to prevent pinching.
Always support small logs on a sawing stand or another log while bucking.
Removing and charging the battery
1) Press the lock button on the top center of the battery to slide it out of the product.
2) Place the battery pack into the charger by sliding it into a locked position until it clicks
3) When the green light is flashing, the battery is charging. If the green light is no longer flashing,
the battery is fully charged.
5. TRANSPORTATION
5.1 TRANSPORT THE MACHINE
Transporting the machine may require that you meet certain requirements specific to your
country. Please make sure to respect them by contacting the authorities of your country, in
order to respect them all.
Let the machine cool for hours outside before transport it. Ensure temperature during
transportation will never be out of temperature range given on chapter storage. Protect the
product from any heavy impact or strong vibrations which may occur during transportation in
vehicles. Secure the product to prevent it from slipping or falling over.
5.2 TRANSPORT THE LITHIUM BATTERIES
Please refer to the battery instruction manual for further details.
6. WINTERING & STORAGE
6.1 STORE THE MACHINE
Let the machine cool for 2 hours outside before storing it. Be sure to secure the unit while
transporting (put back the hand guard guide bar cover). Examine the unit thoroughly for worn,
loose or damaged parts. Clean the product before storing.
Only store the machine in a clean, dry, ventilated place with a temperature range of 4°C to
24°C. Cover it in order to provide added protection. Do not expose the product to sunlight. Make
sure the product is always protected from cold and humidity. We recommend using the original
package for storage or covering the product with a suitable cloth or enclosure to protect it
against dust.
6.2 STORE THE LITHIUM BATTERIES
Please make sure that the battery power level is as recommended in the battery instruction
manual. Please refer to the battery instruction manual for further details.
207
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN