Orthofix AccelStim Manual De Instrucciones página 11

DEVICE OPERATION
The AccelStim device can be powered in two modes:
•
Using internal battery mode. When the internal battery is fully charged, the
AccelStim device can deliver up to five treatments.
•
Using the external power supply, the unit is powered while recharging the
internal battery.
NOTE: The battery must be fully charged before using the device for the first time.
Performing a Treatment
Step-by-step instructions for device application can be found in the table below.
To Apply
The AccelStim device, gel, transducer, transducer holder, and strap will be needed to
treat your fracture. The strap is not needed if you are in a cast for your fracture. If your
physician has placed an 'X' on the fracture site this is the spot that the transducer
holder and transducer will need to be placed directly over.
Check the transducer and the transducer cord before starting treatment. If there are
any signs of damage (cracks, etc.) do not use the AccelStim device and contact Patient
Services at 1-800-535-4492.
PRECAUTION: This AccelStim device is nonsterile and does not require sterilization
before use. Placement on an open wound is not advised.
1. Connect the transducer to the AccelStim device by inserting the transducer
cord into the transducer port. Keep the white dot on the connector
over-mold facing upwards.
2. Open the blue cover of the transducer holder by rotating it
counterclockwise.
3. Place the transducer holder over the area that will receive treatment and
secure with the Velcro attached to the elastic strap. The strap should be
snug, comfortable, and against the skin to prevent motion or slippage. Do
not overtighten the strap. Excess strap can be cut if needed to adjust
the transducer holder over the fracture site.
4. Apply the gel to the side of the transducer with no writing to form a 1-2
mm thick layer. Use a finger to spread the gel on the transducer to obtain
an even layer.
10