Marklin Digital 60996 Manual De Instrucciones página 25

• All of the functions can be controlled according to the
function mapping (see CV description).
• See the CV description for the DCC protocol for additional
information.
We recommend that in general programming should be
done on the programming track.
Physical Functions
Each of these functions must be connected externally to the
circuit board. We therefore speak of physical functions. A
unique mode/effect can be assigned to each physical output
(AUX / lights) in digital operation. Three CVs are available for
each output for this purpose. Only one mode/effect can be
set for each output. A complete table for this can be found
on the Internet at:
http://www.maerklin.de/de/service/technische-informa-
tionen
Logic Functions
Since these functions are only executed by software, no
physical output is required for them. We therefore speak
here of a logic function.
Acceleration/Braking Delay
• The acceleration and braking time can be set separately
from each other.
• The logic function ABV can be assigned to any function
button by using the function mapping.
Switching Range (RG)
• The switching range causes a reduction in the current
speed of the locomotive. This allows a ne touch in the
controlling the locomotive. The switching range can be
assigned in mfx and DCC to any function button by using
the function mapping. See table on page 32 for setting CV,
CV 145 or mfx menu for the Central Station.
Decoder as a Function Decoder without Motor
Outputs
The outputs Motor 1 and Motor 2 can be switched to enhan-
ced function outputs (each max. 500 milliamps) when the
decoder is used as a pure function decoder.
Set the value 0 in CV 52 to do this.
Decoder functions and CV settings
The following pages have the functions and the CVs
presented in tabular form. These CVs can be given a number
of settings and can be assigned to a number of function
buttons.
You will nd the CVs and their applications for the fx (MM)
and DCC protocols in separate tables.
In the mfx protocol, you can set the CVs with ease by means
of the display for the CS 2 (Software Version 4.0 and higher) /
CS 3. You or your dealer may have to install an update on your
60213/60214/60215 Central Station.
25