Nash Siren R4 Manual Del Usuario página 8

muted the LEDs will be seen but start up/power down
tone sequences will not be heard.
PROGRAMMING R4 HEADS TO R4 RECEIVER:
NOTES:
•
•
Press and hold Power
together for 3 seconds until a bleep is heard.
LED 1 will light and stay lit. Sounding an R4 alarm will
pair it to that channel. Pairing is confirmed when the
LED on the Receiver flashes. Short press the Power
button
sequentially paired in this way through channels one to
four.
Once you have paired all the R4 heads you require
press and hold Volume
3 seconds to exit programming, signified by a double
bleep.
The fifth channel (Buddy Channel) can be paired with
your friends' or partner's alarms, so you can go to their
aid if they have a take. Up to 32 different R4 alarms can
be paired to it. To pair R4 heads with the fifth channel
enter programming mode by pressing and holding Power
a bleep is heard.
Short press the Volume
the Receiver will light and stay lit. When an R4 alarm
sounds and is successfully paired the LED flashes. Short
press Volume button and the LED lights and stays lit,
ready to pair with further R4 heads on the same channel.
Once you have paired all the R4 heads you require
press and hold Volume
3 seconds to exit programming, signified by a double
bleep.
8
Instruction Manual.indd 8 Instruction Manual.indd 8
It is easiest to programme R4 heads to the R4
Receiver when the R4 heads are on Sensitivity
Setting 1 (Factory setting).
During programming the Receiver and R4 alarm
must be at least 50cm apart.
to light the second LED. R4 alarms can be
and Volume
and Volume
and Power
buttons together for 3 seconds until
button, and the fifth LED on
and Power
buttons
buttons for
buttons for
25/01/2022 12:3 25/01/2022 12:3