Nash Siren R4 Manual Del Usuario página 9

NOTE: When in pairing mode, if no signal from an R4 head
is registered within 10 seconds the R4 Receiver returns to
normal operation, no new paired channels will be saved and
the R4 Receiver reverts back to the previously stored pairing
information.
ERASING PROGRAMMED R4 ALARM HEADS FROM
THE R4 RECEIVER:
Press Power
without releasing. After 3 seconds the first LED will
light and a bleep will be heard.
Continue to keep both buttons depressed together for
a further 3 seconds, until three consecutive bleeps are
heard and the LED turns off. This signifies any existing
pairings with R4 alarms have been erased. Note individ-
ual heads cannot be selected and erased from the R4
Receiver, all pairings will be erased.
However, individual channels can be overwritten with a
new head, or left paired to the same head by toggling to
the next channel.
You can then go back into pairing mode by pressing
Power and Volume together until you hear a single bleep
and the first LED lights. Now pair your heads accordingly.
NOTE: Individual R4 heads cannot be redistributed between
channels as a single head cannot be paired on two channels
at the same time using the same receiver. If the order of
alarms and channels need to be altered, erase all pairing
information and re-start the programme mode.
VOLUME:
Short press of the Volume
settings are available. Each consecutive short press of
the Volume
level. The bleep you hear represents the volume being
set.
TONE:
The R4 Receiver replicates the tone of each R4 head it
is paired to.
Instruction Manual.indd 9 Instruction Manual.indd 9
and Volume
button. Eight volume
button changes volume output by one
Buttons together,
9
25/01/2022 12:3 25/01/2022 12:3