WARNING!
IT IS VITAL TO HAVE A GAUGE DIAL. IT IS SUPPLIED WITH THE
ENGINE. IF IT IS NOT PROVIDED, CONTACT YOUR DEALER.
DO NOT USE E10, E85, ETC. TYPE BIOFUELS.
A standard US type sensor is used:
Impedance (tank empty position) 30 Ohm
Impedance (tank full position)
All the dials on the market are compatible, with a few very rare exceptions.
To connect it, refer to the electrical diagram.
WATER/FUEL SEPARATING FILTER (IF THE BOAT IS FACTORY RIGGED)
To protect the engine, a water separating fuel filter is fitted to the engine fuel supply line.
Ref.
DESCRIPTION
1
Water/fuel separator filter
Replaceable filter cartridge
2
Make sure that there is no water in the metal bowl each time you use your boat:
-
Slightly unscrew the drain cap (do not remove it completely);
-
Drain the water;
-
Screw the drain cap back on if only fuel remains in the bowl.
Repeat the operation more often if your engine does not run properly.
Using the fuel supply circuit cut-off valves
-614609-
FUEL CIRCUIT
240 Ohm
1
2
31
E
N
G
L
I
S
H
Edition 1