Publicidad
Idiomas disponibles
Idiomas disponibles
Programming instructions
1) Programming open & close limits
2) Programming hand transmitters
a) Press and hold SET Button until 1 appears on the
display then release the button.
The door opener is now in Programming Mode.
b) Press and hold the UP until the door reaches the
desired open position.
NOTE: Fine adjustments can be made by toggling UP
&DOWN buttons
c) Now press the SET button to confirm the position. The
display will now indicate the number 2.
d) Next press and hold the DOWN button until the door
reaches the desired close position. For fine adjustments
toggle UP & DOWN buttons.
e) Now press the SET button to confirm the close position.
CAUTION: The door will now cycle open and close to set
the travel limits and force sensitivity adjustments. The door
is now set for normal operation.
NOTE: Hand transmitters that are supplied with the door
opener are pre-programmed.
a) Press the CODE button. A dot will be indicated in the
corner of the display.
b) Now press the button on the hand transmitter you want
to use, pause for 2 seconds, then press the same button
on the hand transmitter again for 2 seconds.
The dot on the display will flash to confirm the code, then
turn off.
Repeat the process for additional remotes that need to be
stored.
12
www.ELITETOOLS.co
Keep Working
Publicidad
