Elite MG700 Manual De Usuario página 42

Opener stops
automatically after
running 10cm
Digital display
Door is up moving only.
Do not work in down
moving and the Digital
display
The door is fully open,
automatically close after
some time
LED lights flash 4 times
When the door stops, the
caution light is always on
LED lights do not work
Door is automatically
reversed to the upper limit
before the door closed
completely
Door automatically stops
while opening
The remote control
cannot be used or the
operation distance is
short
The wire between gear motor
and board is plugged
inversely
Photo cell function has been
effective
but without connecting any
photo cell device.
Automatic closing function
is turned on
The power board is broken
1. The LED wire is not
plugged
2. The LED is broken
3. The circuit board is
broken
In operation with automatic
reverse function
The door is not installed
correctly
There is some block on its
moving
In operation with automatic
protect function when
obstruction is detected
The door is not installed
correctly
There is some block on its
moving
1. Flat battery
2. Antenna is loosed or not
well extended
3. Interference around
nearby
22
Power off firstly, open the cover and
reverse the plug wire between gear motor
and board. Re-set limit traveling.
Turn off the photo cell function if there is
no any photo cell device connected. (
Refer the instruction manual)
2. Check if the photo cell is connected
correctly, or if there is any obstruction
between the photo cell.
Set the automatic closing time, or turn off
the automatic closing function.
( Refer the instruction manual).
Replace the power board.
1. Check the LED wire
2. Replace the LED
3. Replace the circuit board
1.Check the block position of the door
and re-set the limit traveling
2. Increased force number for automatic
reverse
1.Check the block position of the door
and re-set the limit traveling
2. Increased force number for automatic
reverse
1. Replace new battery
2. Extended the antenna on the opener
3. Get rid of interference
Keep Working