Publicidad
Idiomas disponibles
Idiomas disponibles
5) Automatic closing
Increase A/C time
Auto Close enabled
Increase A/C time
Auto Close disabled
6) Photo electric safety beam
Photo Beam enabled
Photo Beam disabled
NOTE: We recommend that Safety Photo Beams be
used in any installation where the Auto Close function
is enabled.
a) Press and hold UP button until a horizontal bar is
indicated on the display. Now press UP button once to
set the auto close time (in minutes).
b) Press UP button to increase the time, or DOWN
button to decrease the time.
The Maximum time is 135 seconds. To disable Auto
Close, set time to zero (0).
c) Press SET button to confirm the set.
NOTE: Make sure the photo beam has been correctly
installed and use Normally Closed contacts to the
accessory terminals of the opener (Figura 15,
Figura16)
Also note that the photo beam function must be
disabled if NO photo beams are fitted, otherwise the
door cannot be closed, and the LED will blink once time
as an indication.
a) Press and hold the DOWN button until 11 appears
on the display. To enable the photo beam option press
UP again, the display will indicate a H(enabled) or
press DOWN button to disable (display 11) the option.
b) Press SET to confirm the set.
14
Keep Working
Publicidad
