Publicidad
Idiomas disponibles
Idiomas disponibles
13) Metal bottom plate, stronger and security.
14) O/S/C button (A)
Front panel open / stop / close buttons for operation. (picture below)
15) External mains power fuse (B) (picture below)
Figure 1
Pre-installation recommendations
1) Garage door must be able to be lifted and closed easily by hand and without much effort. A
well balanced & sprung door is critical for proper installation.
2) The garage door opener can't compensate for a badly installed garage door and should not
be used as a solution for a "hard to open" door.
3) If the unit is being installed on an existing door, make sure any existing locking devices are
removed or warranty will be void.
4) An approved outlet must be installed near where the opener is begin installed.
5) There should be a minimum gap of 30mm between the bottom of the chain drive rail and the
top of the garage door at its closest point. (refer to Figure 2.)
Important :
As for additional safety rules, we strongly recommends the fitting of Photo Electric safety
beams on all installations.
4
Keep Working
Publicidad
