Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Timer function
There are two versions of the timer function:
• An independent timer from 1 to 59 minutes: it beeps when
the time has run out. This function is always available and is
indicated by the clock symbol (24) which is located between
the - and + buttons (the symbol may be less bright if another
cooking area timer has a remaining time that is less than that set
on the independent timer).
• A timer from 1 to 59 minutes for each cooking area: it beeps
when the time has run out and turns off the cooking area
where it was set. The 4 cooking areas can be programmed
independently (the symbol may be less bright if another cooking
area timer has a remaining time that is less than that set on the
independent timer).
The type of timer activated is shown in the dedicated displays
(19-20-21-22). The timer with the least time is highlighted and
the related clock icon is brighter (13-24). The other timer settings
are still active and running, but the clock icon (13-24) will be less
bright.
Another icon with the word "min" (23) appears when you set times
longer than 10 minutes. For example 0.11 indicates 0 hours and
11 minutes.
The separator dot (21) flashes when the timer is running, while the
dot is static while the timer is selected and thus modifiable.
Independent timer
• If the touch display is on, the independent timer can be used by
simultaneously pressing the + and - buttons. If all the cooking
areas are in position "0", this is the only timer available. The
clock icon (24) will turn on and the display will show "0.00".
If you do not select any button, the timer deactivates within 5
seconds.
• The time setting (0-1hour.59min) can be changed in increments
of one minute with the + button from 0 to 99.
• Holding down the + or - button dynamically increases the rate of
change up to a maximum value, without beeps.
• If the + (or -) button is released, the rate of increase (decrease)
starts again from the initial value.
• The timer can be set by either continuously pressing the + or -
buttons or by pressing successively (with beeps).
After the timer is set, it begins to count down. The expiry of the time
is signalled by a beep or by the flashing of the timer display, which
will show "00".
The beep will not stop until the + or - button is pressed. The display
stops flashing and turns off.
Turning off/changing the timer
The timer can be changed or turned off at any time by turning on
the touch display again, if no cooking area is on, and pressing the
+ and - buttons simultaneously to select the timer. At this point, set
it to "0" by pressing the - button, to turn it off, or by pressing the +
button to increase the time setting.
The independent timer remains active even when the On/Off
button is pressed
8
Programming the timer for the cooking
areas
By turning on the touch display, you can program an independent
timer for each cooking area.
• At least one cooking area must be on and set to a certain level.
• By pressing the + and - buttons simultaneously, you can set
a countdown for turning off the cooking area. There are
illuminated clock icons (13) next to the display of the cooking
area. To set the timer on a cooking area when there are more
than one cooking area on, you must press the + and - buttons
simultaneously. You will note that the clock icon will light and
move to the various cooking areas each time you simultaneously
press the + and - buttons.
• When the timer of the cooking area is selected, the related
clock icon near the display becomes brighter (13). The timers
programmed for each cooking zone remain active.
• Other functions of the timer are the same as the independent
timer. To increase the time, use the plus button.
• The expiry of the time is signalled by a beep and "00" on the
display and the LED of the cooking area assigned to the timer
flashes. The cooking area is turned off and an "H" is shown if
the area is "hot", otherwise the display shows a hyphen. The
beeping and flashing of the display stop.
• Automatically after 2 minutes.
• When you press the + or - buttons, the timer display turns off.
Publicidad
