Eurocave Revelation Modo De Empleo página 36

Your EuroCave cabinet is a tried and tested appliance.
Maintenance operations to be carried out
approximately once a year
•
Unplug and unload the appliance.
•
Clean the water drain at the bottom of the wine cabinet. Pay attention that nothing
is blocking this drain.
•
Regularly vacuum the condenser at the back of the appliance.
•
Clean the inside of the compartments with water and a gentle cleaning product.
•
Rinse thoroughly.
•
Dry it with a soft rag.
•
Replace the active charcoal filter in the breather hole at the top of your cabinet
•
Remove the charcoal filter manually. It is available from your usual retailer. It must be
replaced by an original manufacturer' s part.
•
Check that the seals are in good condition. It is often necessary to clean the door
seal. Using unsuitable cleaning products can cause premature ageing of the seals.
Certain rules must therefore be followed: whenever you clean the seal, always rinse
off any cleaning product with clear water. All traces of cleaning product must be
removed from the seal. EuroCave only recommends using a mild soapy solution. If this
proves insufficient, it is possible to occasionally use an ethanol-based solution,
provided that the concentration used is less than 10% and that the seal is then rinsed
thoroughly with clear water.
Stainless steel:
•
To clean the stainless steel surface, we recommend a neutral liquid soap solution.
•
Make sure that the soap does not contain abrasive additives that might harm the
finish.
Never pour liquid directly onto the stainless steel. Never use chemical solvents, abrasives or granular cleaners, petrol or alcohol, all of which could
harm the cabinet surface. No chlorine-based products.
Caring for glass elements:
•
To clean the glass elements of your cabinet (all doors and the glass handle supplied with Full Glass and Black Piano doors only), use a non-abrasive soft cloth which has had a suitable
glass cleaning product applied to it.
Possible incidents
The pictogram is displaying
The pictogram is still displaying
even though I have taken the corrective
actions above
The pictogram is displaying
The pictogram is flashing
The appliance cannot lower the level of
humidity to the desired value
The pictogram is displaying
The pictogram is displaying
18
GB
Minimum duration of guarantee offered by the manufacturer: 5 years parts.
7/ EVERYDAY MAINTENANCE
8/ OPERATING FAULTS
Causes Corrective actions
The temperature has Check that the door is correctly closed.
not returned to within Check the condition of the door seal.
the ±4 °C threshold If you placed a large amount of bottles in your cabinet in the last few hours,
wait a while then check again. If the alarm is still displaying, contact your
EuroCave retailer.
Operating fault Unplug the cabinet and contact your EuroCave retailer.
Open door alarm Make sure that the door is correctly closed.
The level of relative • Pour a glass of water into the duct of the tray (see chapter 7, § IV).
humidity has been < • In order to know how often to add water, count the number of days
50 % for over 72 hrs separating the 1st day you added water and the day when the pictogram was
displayed
After a few hours, the pictogram will disappear.
• Empty the cabinet, remove the humidity cartridge and clean the tray.
• Remove the black drainage tube placed at the bottom of the cabinet.
The humidity will be directly discharged out of the appliance.
Call the EuroCave retailer if the problem persists despite having carried out
these different operations.
Charcoal filter alarm Replace the charcoal filter (see chapter 6).
Temperature sensor Contact your EuroCave retailer.
fault alarm
•
Clean the light strip with a microfibre
or soft cloth only. Never use cleaning
products containing alcohol.
•
To remove text, written using the
white marker pen, from the bottle
identification supports, use a damp
cloth.
•
To clean the fronts of the shelves:
- use a microfibre or soft cloth only
- only use water or a cleaning product designed for glass
Never use cleaning products containing acetone, spirit or alcohol,
white spirit or synthetic thinners which could damage the front
of the shelf.
•
Apply solution with a soft cloth.
•
The cloth should not have any buttons, zips etc. that might scratch the stainless steel.
•
Rub the surface following the brushed direction.
•
Dry with a soft clean cloth following the brushed direction.