Publicidad
Idiomas disponibles
Idiomas disponibles
7.
CONNECTION TO THE MAINS
1. Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
to the appliance (see picture 3). . Ensure that the supply socket:
I
requirements of the rated current as set out on the rating plate;
thermal-magnetic switch with In = rated value as stated on the rating plate; - differential with Id sensitivity
UK
3
= 30 mA. . Ensure that there is no danger of explosion (AD) in the room. . Make sure the environment
is suitable for the power supply cable provided. The cable of the appliance is H05 VVF, designed for
D
internal use. . Insert the plug in the socket (do not use three-way adapters and reduction adapters).
N.B.: if the equipment has been transported or stored overturned, let is rest in its correct position for at
E
least 3 hours before hooking it up to the mains.
F
8.
OPERATIONS AND ADJUSTMENT
NL
The equipment controls are located in the control panel:
(1) Electronic control panel: Gives tank temperature
(2) Refrigeration switch: Use to connect the cooling system
P
(4) Light-lift switch: Use to switch on the light and raise the hood
The temperature of the equipment can be adjusted by pressing the
S
set cell temperature (on the screen). Press the
"DOWN" Key (8)
press the
DK
!
CAUTION: Before placing goods ensure that:
FIN
1.
the plug is connected;
B
desired temperature for the goods to be stored; . appliance is not exposed to direct sunlight or to
powerful lamps;
GR
ROUTINE MAINTENANCE
9.
Once a week: for equipment in continuos operation
CZ
Every evening: for intermittent daily use
1
. Disconnect power. . Remove goods and place them in a suitably refrigerated place. . Defrost the
EE
evaporator by suspending operations for approximately one hour. . Clean the walls and accessories with
a sponge dampened with water and sodium bicarbonate and dry carefully.
LV
10.
REPLACEMENT OF THE LAMP
LT
1
. Open the cover. . Switch off the appliance.
4
place. . Remove the lamp socket, whilst holding the fluorescent tube and its protective cover. . Pull the
H
protective cover out of the other lamp socket. . Replace the fluorescent tube. . Refit all components by
following the above instructions in reverse order (see picture 6).
M
PL
SK
SLO
2
5
to decrease the temperature
2.
the refrigeration unit switch is on (green light lit up); . thermometer shows the
5.
ambient temperature does not exceed +30°C with 55% R.H. (climatic class 4);
2
2
Operator's guide
c)
"UP" Key (7)
several times to increase the temperature, or
(see picture 2)
4
3.
Remove the screws securing one of the lamp sockets in
6
7
is properly earthed;
fulfils the
a)
b)
complies with the IEC regulations:-
4
"SET" key (6)
(just once): to display the
3
3
4
7
5
Publicidad
