cecotec BOLERO COOLMARKET FD 510 INOX E Manual De Instrucciones página 33

ENGLISH
- This refrigeration appliance is not suitable for built-in installation.
- Remove all packaging, including the plastic protection on the bottom of the appliance and
the adhesive tape securing the shelves and door compartments inside.
- Place the refrigerator in a suitable position and adjust the feet to level it. It is recommended
to clean the appliance with a hot, soapy cloth and dry it thoroughly before use.
- Place the refrigerator and adjust its height, clean it, let it rest for 4 to 6 hours, and switch
it on. This will help ensuring that the compressor oil has properly settled, and that the
appliance is running normally.
3. OPERATION
Installation size. Fig. 3
Select an appropriate level-surfaced location to place your appliance for easy use. Avoid
placing the appliance near heat sources, under direct sunlight, or in moist environments.
A B C D E F
(mm) (mm) (mm) (mm) (mm) (mm)
621 836 1774 1830 706 1521
- The above values are indicative for installation purposes. Actual sizes may vary slightly.
- To ensure that the appliance runs at maximum efficiency, allow enough space around the
appliance as shown in Figure 4.
Installation location
- The refrigerator must be placed on a solid, flat surface.
- If cushioning is necessary, use stable, solid, and non-flammable cushioning blocks.
- DO NOT USE FOAM PACKAGING AS CUSHIONING BLOCKS!
- The appliance should be kept away from damp or wet environments. Water or dirt should
be removed from any surface of the appliance as soon as possible with a soft cloth. This
will help prevent rust and help your appliance run at maximum efficiency.
- Place the refrigerator in a well-ventilated place, reserve some space around and behind
the refrigerator, and do not cover or block the air grille of the compressor rear cover plate
at the back of the refrigerator. Keep the refrigerator away from heat sources or direct
sunlight.
Adjustable feet. Fig. 5
- In the refrigerator packing box, feet come tightly packed. After removing the refrigerator
from the box for installation, be sure to adjust the two front feet to the desired height;
adjust the two feet with a spanner or directly by hand.
64
BOLERO COOLMARKET FD 510 INOX E / DARK E / WD INOX E / GLASS E
Height M
(mm) (mm)
382 1076
- The feet and rear rollers must touch the floor to prevent the refrigerator from moving,
vibrating, or rattling.
- When moving the refrigerator, adjust the feet counterclockwise so that they do not touch
the floor, then gently tilt the refrigerator to start moving it.
Start-up
- Connect the power cord and turn on the switch.
- On first use, the display will show the respective default temperature values (refrigerator
compartment is set to 5°C, freezer compartment to -18°C).
- The default mode is the power-saving mode, with the display timeout time being 20
seconds. This mode saves energy and increases the lifespan of the LED lights.
Selecting modes and functions
Each time you press the Function button, you will cycle through the different operating modes.
Holiday mode
The refrigerator compartment will run at 8°C while the freezer compartment will run at -15°C.
Fast Freezing function
Fast Freezing function: the freezer compartment will run continuously to freeze food faster
and keep it fresh. The Fast Freezing function will automatically switch off after 24 hours of
operation or when the freezer compartment reaches -28°C. When this occurs, the Fast Freezing
icon will turn off and the freezer compartment will continue running at default temperature.
Fast Cooling function
By selecting the Fast Cooling function, the refrigerator compartment reaches the set
temperature in the shortest possible time to keep food as fresh as possible. When you enable
this function, the refrigerator-compartment temperature will be set to 2°C automatically.
The programme lasts 150 minutes maximum and switches off automatically. When the Fast
Cooling icon switches off, it means the Fast Cooling function is inactive, and the temperature
setting reverts back to the one chosen before enabling the Fast Cooling function.
Freezer-compartment settings. Fig. 6
The default temperature of the freezer compartment is -18°C. To change the temperature,
press the Freezer-Compartment Temperature Control button to view all the setting options.
WARNING
: do not place fresh food directly on top of frozen food.
Refrigerator-compartment settings. Fig 7
The default temperature of the refrigerator compartment is 5°C. To change the temperature,
press the Refrigerator-Compartment Temperature Control button to view all the setting
BOLERO COOLMARKET FD 510 INOX E / DARK E / WD INOX E / GLASS E
ENGLISH
65