Descargar Imprimir esta página

Mr Coffee JPX37-R Serie Manual Del Usuario página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

– Delay Brew – Would you like to wake up to a fresh
pot of coffee? The timer allows you to preset when
you would like the coffeemaker to automatically begin
brewing your coffee, up to 24 hours in advance.
– Special Cleaning Cycle – Enables you to easily maintain
and clean mineral deposits from your coffeemaker.
NOTE: If you have selected any of the operating functions,
the coffeemaker will act upon the last operation selected if
the power is restored within 7 seconds after a power outage.
CLEAN YOUR COFFEEMAKER BEFORE USING THE
FIRST TIME
Make sure your first cup of coffee is as good as can be by
cleaning your MR. COFFEE
Coffeemaker before its first use.
®
Just follow these simple steps:
1. Wash the decanter, decanter lid, permanent filter,
water filtration, and the filter basket in a mixture of mild
detergent and water. Rinse each thoroughly (please refer
to the parts diagram listed above).
2. Replace all the parts and close the lid. Then, run a brew
cycle with water only, without adding coffee and coffee
filter.
3. When brewing is complete, turn your coffeemaker off,
discard the water in the decanter and rinse the decanter,
decanter lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
SETTING THE CLOCK AND
DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a
standard electrical outlet. The
clock will flash on the control panel to indicate that the
time has not been set yet.
10
2. Press and hold the HOUR and
MINUTE buttons until you reach the
current time. The AM or PM indicator
will light at the left of the display (
Figures 1 and 2).
The clock is now set!
NOTE: Pressing Brew Now/Off or Clean
buttons before setting the clock will
cause the clock to start keeping time
from 12:00 a.m. You must set the clock if
you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode,
simply press the SET DELAY button (Figure
3) and, while the DELAY BREW time is
flashing, set the brew time by pressing
the HOUR and MINUTE buttons. The AM
or PM indicator will light at the left of the
clock display. (Figure 4)
Within a few seconds the display will
change to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle,
see the "Brewing Coffee Later" section.
Figure 1
Figure 2
Figure 3
Figure 4
11

Publicidad

loading