Publicidad
Idiomas disponibles
Idiomas disponibles
C. Adding Water and Ground Coffee
1. Open the brew basket lid. For your
convenience, you can lift out the
removable filter basket.
2. Place the MR. COFFEE
nylon
®
permanent filter included into the
removable filter basket (Figure 5).
NOTE: If using paper filters instead of
the nylon permanent filter included, it
is important that the sides of the filter
fit flush against the side of the filter basket. If filter collapse
occurs, dampen the filter before placing in the filter basket
and adding ground coffee and water.
3. Add the desired amount of coffee and gently shake to
level the coffee. See the Suggested Coffee Measurement
Chart.
4. After following instructions in the Water Filtration
System, place the MR. COFFEE
making sure that the side marked "this side up" faces you
and that the water filter is level.
5. Be sure the removable filter basket is properly centered
and all the way down in the brew basket and close the lid.
6. Fill the decanter with cold, fresh water to the desired
capacity (1 cup = 5 fl. oz./ 148ml) For easy and accurate
filling, the water markings on the glass decanter and on the
water window show the amount of water needed to make
the corresponding desired number of cups. Do not fill past
the "12 cup MAX line" or water will flow out of the overfill
hole in the back of the coffeemaker.
The amount of coffee brewed will always be slightly less
than the amount of water poured in the water reservoir.
This is due to the minimum absorption of water by the
coffee grounds.
7. Lift the brew basket lid and pour the water into the
water reservoir. Close the lid and place the empty
decanter onto the warmer plate.
14
Figure 5
water filter in the basket,
®
NOTE: Make sure the decanter is fully placed on the warming
plate or the water and the grounds will overflow from the
filter basket. An overflow may cause personal injury or
damage to property.
CAUTION! To reduce the risk of damaging the
decanter and/or the risk of personal injury, do not
add cold water to the decanter if the decanter
is already hot. Allow the decanter to cool before
using.
BREWING COFFEE NOW
1. To enjoy a more full flavored cup of
coffee, press the Strong Brew button
once. The STRONG Strong Brew red
light will turn on. The coffeemaker will
remain in the Strong Brew mode until
you change it back to regular strength
by pressing the Strong Brew button
again and light turns off or until you
unplug the machine. (Figure 6)
NOTE: Once brewing has started the
Strong Brew cannot be changed during
the brew cycle. The coffeemaker
automatically defaults to regular strength.
2. Complete the steps in the Adding
Water
and Coffee section and with the
glass decanter and the filter basket
securely in place, turn the coffeemaker on by pressing
the Brew Now/Off button once. The Brew Now/Off
button will pulse during the brew cycle. (Figure 7).
Figure 6
Figure 7
15
Publicidad
