Every technical change has
an effect on the operation or
safety of the appliance and
must therefore be performed by te-
chnical personnel of the manufactu-
rer or by technicians who are for-
mally authorised by the same.
Failure to do so exempts the manu-
facturer from any liability for for any
possible resulting modifications or
damage.
Upon arrival, check the integri-
ty of the appliance and its com-
ponents (e.g. power cord), pri-
or to use. In the presence of faults
do not start the appliance and con-
tact the nearest service centre.
Read the instructions before
acting.
tions to be performed. As far as per-
sonal
protective
concerned, the European Commu-
nity has issued Directives which the
operators must comply with. Noise
≤ 70 dB.
It is forbidden the installa-
tion of stand alone equip-
ment WITHOUT anti-tip kit
(ACCESSORY).
excluded.
Before
making
nections check the technical
data shown on the rating plate
of the appliance and the technical
data in this manual. It is strictly for-
bidden to tamper with or remove
the plates and pictograms ap-
plied to the equipment.
The appliance has to be in-
stalled and used in such a
way that any water cannot
contact the fat or oil.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear
protective
equipment suita-
ble for the opera-
equipment
TOP
versions
the
con-
- 5 -
Disconnect all supplies, if
present (e.g. water - gas -
electrical) upstream the appli-
ance whenever you need to work in
safe conditions.
Connect the appliance if pre-
sent, in the sequence of the
water, then to the gas network. En-
sure there are no leaks then proce-
ed with the connections to the
mains.
The appliance is not designed
to work in an explosive atmo-
sphere and as such its instal-
lation and use is categorically prohi-
bited in such environments.
Position the entire structure,
respecting the installation di-
mensions and characteristics
indicated in the specific chapters of
this manual.
The appliance is not intended
for recessed installation. / The
appliance must be used in a
is
well ventilated area. / The appliance
must have free drainage (not hinde-
red or impeded by foreign bodies).
The gas equipment must be
installed beneath an extrac-
tion hood whose system must
have specifications in compliance
with the current regulations in the
country of use.
Once the appliance is con-
nected to the power and drain
sources, it must remain static
(fixed) in the place of use and main-
tenance. Incorrect connection may
cause danger.
Drainage of the appliance
must be conveyed into the
grey water discharge network
in an open "glass" unsiphoned for-
mation.
2.
EN