Bosch GCM12SD Manual Del Usuario página 22

BM 2610007877 08-10:BM 2610007877 08-10.qxp 8/24/10 1:04 PM Page 22
WARNING
source before
adjustment or repair.
Adjusting 0° Bevel Stop
(Blade 90° to Table)
1. Pull up the bevel lock lever to loosen.
2. Loosen bolt heads "A" and "B" using a 10mm open
end wrench or socket (with socket wrench).
Loosen bolts at least one full turn (see Figure 23).
3. Loosen set screw "D" using the 4mm end of the
6/4mm hex key (provided with tool, but may also
use a standard 4mm hex key). Loosen screw at
least three full turns.
djustments
0° Bevel Stop – Adjustment procedure
To avoid possible
disconnect plug from power
performing any assembly,
Adjusting Bevel Stops
4. Place combination square on table and against
injury,
blade (see Figure 22).
5. Using the 4mm end of hex key, turn set screw "C"
and watch the saw blade tilt. Turn screw "C" until
the blade is aligned (full contact) with the square's
body's edge. After aligning, remove hex key.
6. Tighten set screw "D" using 4mm hex key.
7. Tighten bolt heads "A" and "B" using 10mm open
end wrench.
8. Adjust bevel scale pointers (item 36 – page 9) to
be in line with the bevel scale's 0° lines.
9. Push down the bevel lock lever to lock.
figure 23
22.