Bosch GCM12SD Manual Del Usuario página 24

BM 2610007877 08-10:BM 2610007877 08-10.qxp 8/24/10 1:04 PM Page 24
WARNING
source before
adjustment or repair.
Adjusting 45° Bevel Stop
(Saw Blade 45° to Table)
1. Pull up the bevel lock lever to unlock. Move the left
sliding fence fully to the left.
2. Tilt the
(counterclockwise) until it hits the 45° stop.
3. Place only the combination square's head on the
saw's table with its long flat side resting on the
table and its 45° side against the tilted blade.
djustments
45° Bevel Stop – Adjustment procedure
To avoid possible
disconnect plug from power
performing any assembly,
saw assembly to the
Adjusting Bevel Stops
4. Place an 8mm open end wrench on bolt head "F"
injury,
(see Figure 25).
5. While turning bolt "F," watch the blade tilt – turn "F"
until the saw blade plate is in full contact with the
45° side of the square's head (see Figure 24).
6. If needed, adjust bevel scale pointers (item 36 –
page 9) to be in line with the bevel scale's 45°
lines. First, adjust right bevel pointer; then tilt saw
head to the right 45° stop position (see page 41 –
"Bevel Range 2 = 0-45° Right") and adjust the left
left
bevel pointer. Tilt the saw head to the 0° position
– both pointers should be on the bevel scale's 0°
lines.
7. Push down the bevel lock lever to lock at the
desired bevel angle.
figure 25
24.