Bosch GCM12SD Manual Del Usuario página 44

BM 2610007877 08-10:BM 2610007877 08-10.qxp 8/24/10 1:05 PM Page 44
The depth stop adjustment is a feature used when
cutting grooves in the workpiece.
The depth adjustment is used to limit blade depth to
cut grooves.
NOTE: Read and understand all instructions on page
19 in the Adjustments section on "Setting Blade
Depth for Non-Through Cuts for Cutting Grooves."
NOTE: For best results, Bosch recommends the use
of a table saw with an optional dado blade set for
cutting grooves and non-through cuts. In the event
this is not available, the feature described below is a
convenient alternative.
A groove should be cut as a slide cut.
1. For adjustment of groove depth, pull out depth
stop plate and rotate depth stop screw. Rotating
the depth stop screw clockwise will raise saw
blade and rotating the screw counterclockwise will
lower the blade.
2. For minor adjustments, simply rotate the depth
stop screw to the desired location.
Depth Stop
Plate
figure 55. Cutting Grooves
Saw Operations
Cutting Grooves
Depth
Stop Screw
44.
3. Cut the two outside grooves first.
Outside Grooves
Workpiece
figure 56. Rough Cut Groove
4. After cutting a groove, shut saw "OFF" and wait for
blade to stop.
5. To remove material between cuts, move the
workpiece to the right or left. The saw must come
to a complete stop before moving workpiece.