Publicidad
Idiomas disponibles
Idiomas disponibles
6-5 Resistance Measurement
⃝
N ever try to make measurement on a circuit that is not
deenergized.
⃝
D o not make measurement with the battery compartment cover
removed.
⃝
K eep your fingers and hands behind the barrier during
measurement.
a. Set the Function Selector switch to the (
b. Slide the terminal cover to the left. Plug the red test lead into the
V/
terminal and the black test lead into the COM terminal.
Ω
c. Check that the display reads "OL". Then, short the tip of the test
leads together and check that the display reads "0".
d. Connect the tip of the test leads to the circuit under test and take
the reading on the display.
NOTE
When the tip of the test leads is shorted together, the display
◇
may read a very small resistance instead of "0". This is the
resistance of the test leads, not a fault.
If one of the test leads has a break, the display reads "OL".
◇
DANGER
#
Ω
18
̶
̶
/
) position.
Publicidad
