Publicidad
Idiomas disponibles
Idiomas disponibles
Fuel
Note! The machine is equipped with a two-stroke engine
and must always be run using a mixture of gasoline and
two-stroke oil. It is important to accurately measure the
amount of oil to be mixed to ensure that the correct
mixture is obtained. When mixing small amounts of fuel,
even small inaccuracies can drastically affect the ratio of
the mixture.
WARNING! Always ensure there is
!
adequate ventilation when handling fuel.
Gasoline
•
Use good quality unleaded gasoline.
•
The lowest recommended octane grade is 87
((RON+MON)/2). If you run the engine on a lower
octane grade than 87 so-called knocking can occur.
This gives rise to a high engine temperature and
increased bearing load, which can result in serious
engine damage.
•
When working with continuous high revs (e.g. limbing)
a higher octane is recommended.
Ethanol fuel
RedMax recommends commercial available fuel with
maximum 10% ethanol content.
Running-in
Avoid running at a too high speed for extended periods
during the rst 10 hours.
Two-stroke oil
•
For best results and performance use RedMax two-
stroke oil, which is specially formulated for our two-
stroke engines. Mixture 1:50 (2%).
•
If RedMax two-stroke oil is not available, you may use
another two-stroke oil of good quality that is intended
for air cooled engines. Contact your dealer when
selecting an oil.
•
Never use two-stroke oil intended for water-cooled
outboard engines, sometimes referred to as outboard
oil.
•
Never use oil intended for four-stroke engines.
FUEL HANDLING
Gasoline, litre
5
10
15
20
US gallon
1
2 1/2
5
Mixing
•
Always mix the gasoline and oil in a clean container
intended for fuel.
•
Always start by lling half the amount of the gasoline
to be used. Then add the entire amount of oil. Mix
(shake) the fuel mixture. Add the remaining amount of
gasoline.
•
Mix (shake) the fuel mixture thoroughly before lling
the machine's fuel tank.
•
Do not mix more than one month's supply of fuel at a
time.
•
If the machine is not used for some time the fuel tank
should be emptied and cleaned.
Chain oil
•
We recommend the use of special oil (chain oil) with
good adhesion characteristics.
•
Never use waste oil. This results in damage to the oil
pump, the bar and the chain.
•
It is important to use oil of the right grade (suitable
viscosity range) to suit the air temperature.
Two-stroke oil, litre
2% (50:1)
0,10
0,20
0,30
0,40
US . oz.
2 1/2
6 1/2
12 7/8
English
–
19
Publicidad
