Publicidad
Thank You For Choosing Kallista
We appreciate your commitment to KALLISTA quality products. Please
take a moment to review this manual before you install your
KALLISTA product. If you encounter any installation or performance
problems, please do not hesitate to contact us from within the USA or
Canada at 1-888-4-KALLISTA (1-888-452-5547).
Tools and Materials
1/4"
Hex Wrench
Propane
Torch
Before You Begin
WARNING: Risk of scalding. High water temperature can
cause severe burns. Set the water temperature at or below
120°F (49°C) following the adjustment procedure.
IMPORTANT! Risk of product damage. Do not apply direct heat
to the valve. Excessive heat will damage the plastic components and
plaster guard.
IMPORTANT! This valve is not intended to be used as a shut-off
valve. If fewer than three accessories will be installed, complete the
2-way conversion before plugging any outlets.
Observe all local plumbing and building codes.
Do not remove the plaster guard until instructed to do so.
A mixed water supply is required for this valve.
Read these instructions and plan the installation before beginning.
Component location, spacing, and situational requirements can
vary.
Shut off the water supply.
1091987-2-E
Tubing Cutter
Sealant Tape
Plus:
• 1/2" Copper tubing or
piping for outlets
• 3/4" Copper tubing or
Solder
piping for inlets
• 1/2" NPT plug
2
Kallista
Publicidad
