Publicidad
Tools
Pipe
Adjustable
Wrench
Wrench
Assorted
Screwdrivers
10 mm
Hex Wrench
Before You Begin
WARNING: Risk of scalding or other severe injury. Before
completing installation, the installer must set the maximum
water temperature setting of this valve to minimize the risks
associated with scalding hazards according to ASTM F 444.
CAUTION: Risk of personal injury. If the water temperature
is set too high, scalding will occur. The water temperature
should never be set above 120°F (49°C).
CAUTION: Risk of scalding. This device has been calibrated
at the factory to ensure a safe maximum water temperature.
Any variance in settings or water inlet conditions from those
used during factory calibration may raise the discharge
temperature above the safe limit, and may present a scalding
hazard. Responsibility for installation and adjustment of this
device in accordance with these instructions lies with the
installer.
NOTICE: Risk of product damage. This valve contains plastic and
rubber components. Do not sweat or braze directly to the valve
body. Do not apply excessive heat to the valve body when you
make solder connections. Do not apply flux or acids directly to the
valve, as damage to the seals, plastic components, and trim finish
may result.
Kallista
Hacksaw or
Tubing Cutter
Thread
Strap Wrench
Sealant
Thermometer
3
Solder
Propane
Torch
Wrench and
1/2" (13 mm)
Hex Socket
1170591-2-A
Publicidad
