Publicidad
INSTALLATION INSTRUCTIONS
Apply thread sealant.
Run cold and hot water through the shower arm for several minutes to fl ush out dirt and debris.
Install the showerhead as shown.
Secure the showerhead to the shower arm using a clean wrench.
Pivot the showerhead to verify smooth operation.
Run water through the showerhead to check for leaks between the shower arm and showerhead inlet.
Adjust as needed.
1226928-2-A
3 of 3
INSTALL THE SHOWERHEAD
Thread the showerhead on and tighten.
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Showerhead
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Publicidad
