Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
Storing the Machine
For periods of about 3 months or longer:
:
Drain and clean the fuel tank in a
well ventilated area.
:
Run engine until carburetor is dry,
this helps prevent the carburetor
diaphragms sticking together.
:
Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
:
Thoroughly clean the machine,
pay special attention to the cylinder
fins and air filter.
:
If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
:
Store the machine in a dry and high
or locked location, out of the reach
of children and other unauthorized
persons.
46
Checking and Replacing
Chain Sprocket
:
Remove the chain sprocket cover,
chain and guide bar.
:
Disengage the chain brake:
Pull hand guard toward the front
handle.
Replace the chain sprocket:
–
after using two Oilomatic chains
–
or sooner if the wear marks (arrows)
on the sprocket are deeper than
approx. 0.02 in (0.5 mm) since this
would reduce the life of the chain.
You can use a gauge ("Special
Accessories") to check the depth of
the wear marks on sprockets.
It is best to use two saw chains in
rotation with one sprocket.
Use only original STIHL chain sprockets
to ensure correct operation of the chain
brake.
Disassembly
:
Pull off the spark plug boot and
unscrew the spark plug (1).
:
Push the locking strip (2) – wide end
first – into the cylinder and then turn
it 180° clockwise.
:
Rotate clutch clockwise as far as
stop.
MS 200
Publicidad
