swissflex 95RF bridge Modo De Empleo página 22

entitlements will no longer ap-
ply. Handle the _95RF and ac-
cessories with care; do not dis-
assemble or modify them, do
not allow children to play with
them and prevent frail individu-
als from using the product with-
out supervision.
The product may not be used
with a medical device or be in-
stalled in a medical device.
The product may not be used in
an environment in which flam-
mable or explosive gases or va-
pours (e.g. anaesthetics) are
likely to occur.
The product may not be used to
raise and lower loads.
Only use spare parts that have
been produced or approved
by Swissflex. Only these parts
guarantee adequate safety.
The slat base may only be used
with the power supply provided.
Initial setup «Touch»
Place the batteries into the radio remote control
Remove the cover from the battery compartment
(21) on the back of the radio remote control. Place 3
AAA-batteries (22) into the compartment, paying at-
tention to the +/- markings. Close the compartment
cover again. The maximum range of the radio remote
control is 15 metres.
Teaching-in the radio remote control (already
taught-in in the factory)
1. Remove the radio remote control's battery cover on
the back of the device.
2. Insert / check the batteries (3 x AAA).
3. Activate the teach-in button (30) on the switching
power supply (press 2 x).
22
Operating instructions
4. A small red button is located above the batteries in
the battery compartment (21).
5. Press the button; a blue LED will start flashing.
6. Hold the button down until the blue LED is
permanently illuminated; this means that pairing
has been completed.
Bluetooth
®
1. Download the standard „Swissflex" app from the re-
levant platform for Android (Google play) or Apple
iOs (App Store).
2. Install the standard „Swissflex" app onto your
Smartphone / Tablet PC.
3. Installation / Initial setup, see manual of the Blue-
tooth RF-Gateway.
Synchro function (with sync cable)
When two _95RF are linked together with a sync cable
(connection jack (23)), the synchro function (17) is re-
quired. By pressing and holding down the button (17),
the synchro function is activated/deactivated. When
pressing the travel button (6-7), the control systems
synchronise and then move in the confirmed direction
of travel. After successful activation, the button glows
blue continuously. After successful deactivation, the
button appears white. After plugging in the sync cable,
carry out a reset as follows:
• Press down the 'Memory/Save' button (18) for 3 se-
conds.
• The M1-M4 buttons will first light up blue and then
switch to white again.
• The LCD backlighting system will flash white once
after several seconds.
• Immediately press down the synchro button (17)
and keep it pressed down. The control systems po-
wer down.
• If the entire backlighting system flashes white twice,
you can release the synchro button (17).
The internal meter readings for the individual motors
have now been reset to '0' and the sync function can
work correctly.
Under-floor lighting
Activate the under-floor lighting by pushing the „Un-
der-floor lighting" button (8). This switches off auto-
matically after 30 minutes, or if the button is pushed
once again. This button is illuminated (blue) when it is
pushed.
Pocket lamp
The pocket lamp is illuminated when the „Pocket lamp"
button (5) is held down. The light turns off when the
button is released. This button is illuminated (blue)
while the pocket lamp is in use.
EN