Klein Tools MM500A Manual De Instrucciones página 3

A. Use proper safety-rated leads.
Do not attempt to measure more than 750V.
B. Voltage Select Button
• Auto detect AC or DC
C. Resistance / Continuity Button
• Selects Resistance or Continuity Function
D. Auto Hold
• Press the "A-HOLD" button
• Auto Hold captures the first stable displayed value
until a new stable value is measured. The meter
will then capture the new value and emit a beep
(V and Ohm functions).
E. Back Light
• Press and hold the "A-Hold" button to enable
or disable lights. NOTE: Using lights drains the
battery significantly.
F. Auto Power-Off
• Device will power off after 30 minutes non-use.
1. AC Voltage: <750V
A-HOLD
2. DC Voltage: <750V
A-HOLD
3. Resistance: < 4K .
A-HOLD
FEATURE DETAILS
• Press " V
• APO timer resets when a " V
• Holding the " V
G. Battery / Replacement
• When
• Remove back screws and replace 2 x AAA
H. Probe Storage / Receptacle Testing
• To store probes, ensure the collar of the probe
• When testing receptacles, slide the probes into
FUNCTION INSTRUCTIONS
• With the unit OFF or in " " mode, press the " V " button
for voltage. Unit defaults to AC Voltage.
Apo
• Attach RED lead to " V " input, BLACK lead to COM.
A-HOLD
• Display auto detects and shows AC voltage.
• Power the unit OFF by holding the " V " or " /
for one second.
• With the unit OFF or in "
for voltage. Unit defaults to AC Voltage.
• Attach RED lead to " V
A-HOLD
• Display auto detects and shows DC voltage.
• Power the unit OFF by holding the " V " or " /
for one second.
• DO NOT attempt to measure resistance on a live circuit.
• With the unit OFF or in " V " mode, press the " /
Apo
button once for resistance.
A-HOLD
• Attach RED lead to " V " input, BLACK lead to COM.
• Display shows resistance.
• Power the unit OFF by holding the " V " or " /
for one second.
or " / to wake.
" "
measurement is made.
or " /
"
second while turning on disables Auto Power-
Off.
indicator is displayed on the LCD,
batteries must be replaced.
batteries.
fits the probe holder channel and press down.
the probe holder from the top of the unit. The
probe holder is designed to space the probes for
easy testing of receptacles.
" mode, press the " V " button
" input, BLACK lead to COM.
or "
" "
button for one
"
" button
" button
"
" button