Publicidad
Idiomas disponibles
Idiomas disponibles
20 - Oven Door
EN
Automatic door locking during pyrolytic cycle
For safety reasons, the door is locked automatically as soon
as self-clean mode is selected (both standard, both eco
clean). The door is also unlocked automatically when the
clean time has expired but only after the temperature has
fallen below the safety threshold.
NOTE It is not possible to exclude the door locking device
during self-cleaning i.e. manually unlock the door
since the self-cleaning mode has the highest priority
and overrides all other selections.
The lock symbol (
) on the display is:
When the door is fully locked
ON
When the door is fully unlocked
OFF
When the latch mechanism is moving or
FLASHING
is waiting for a command by the electronic
control. (After self clean the symbol will flash
until the temperature will be safe and the door
unlocked).
Removing the "FULL GLASS" panoramic door
WARNING
Make sure that:
• The oven is cool and power to the oven has been turned
off before removing the door. Failure to do so could
result in electrical shock or burns.
• The oven door is heavy and fragile. Use both hands to
remove the oven door. The door front is glass. Handle
care-fully to avoid breakage.
• Grasp only the sides of the oven door. Do not grasp
the handle as it may swing in your hand and cause
damage or injury.
• Failure to grasp the oven door firmly and properly could
result in personal injury or product damage.
Removing the oven door
The oven door can be removed quickly and easily. To do so,
proceed as follows:
• Open the door fully.
• Lift the two levers shown below.
• Close the door as far as the first stop (caused by the
raised levers).
• Lift the door upwards and outwards to remove it fromits
mountings.
To replace fit the door, fit the hinges in their mountings and
lower the two levers
32
How to remove the inner glass of the "FULL
GLASS" panoramic door
1. Wear protective gloves.
2. Place the door on a flat horizontal surface face down on
a soft cloth to avoid scratching the visible part.
3. Remove the two lateral caps and pull out the top strip.
Publicidad
