Publicidad
Idiomas disponibles
Idiomas disponibles
DW9020-30-1103905566:FerClassic_BASE_110x220mm
water from tumble dryers, scented or softened water, water from refrigerators,
batteries or air conditioners, pure distilled or demineralised water or rain water should
not be used in your iron. Also do not use boiling, or bottled mineral water.
USE
1 • Filling the water tank
• Before filling the water tank, unplug the iron fig.2.
• Set the temperature control dial
• Open the filling inlet fig.4. Fill in water up to the Max. mark. fig.5. Close the filler
inlet and return the iron to the horizontal position.
• You can plug in your iron
2 • Setting the temperature
Your iron is equipped with the Autosteam Electronic Control function, it
automatically adjusts the steam amount and the temperature based on the selected
fabric for optimum results.
Select the fabric to be ironed on the thermostat dial. For perfect results, an optimum
position for each fabric has been pre-defined. This position is marked on the dial and
also represented with a louder "click" sound. You can also set your iron based on
the international temperature measurements •, ••, •••. Ensure your thermostat dial is
positioned on these settings.
When your iron reaches the required temperature, the thermostat indicator turns off
fig.7. You can start ironing.
IMPORTANT The iron takes longer to cool down than to heat up. We recommend that
you start with fabrics to be ironed at a low temperature. For mixed fabrics set the
temperature for the most delicate fabric.
TIP Always spray starch onto the reverse side of the fabric to be ironed.
3 • Dry ironing
Set the temperature to suit the type of material without pushing the autosteam trigger and
shot of steam button.
4 • Steam ironing
Your iron is equipped with the Autosteam function. The steam quantity and the
temperature will adjust automatically to the selected fabric. To get continuous steam
squeeze the autosteam trigger
Your iron is equipped with a pump called Steamforce Technology which pushes
30 % more steam into the heart of the fibres. The pump may cause a slight noise. This is not a
technical fault! A few seconds are necessary to produce or to stop the steam.
5 • Shot of steam
Press the shot of steam button to generate a powerful jet of steam
IMPORTANT Leave an interval of a few seconds between each shot and wait until the
flow of steam has finished before standing the iron on its heel.
fig.3
on position (Min.)
fig.6
.
FABRIC
THERMOSTAT
Nylon (Synthetic
fibres, e.g. viscose,
polyester)
silk
wool
cotton
linen
(Autosteam & Steamforce)
fig.8
.
3
3/02/09
17:22
GB
THERMOSTAT
IRONING
INDICATION
LABEL
NYLON
SILK
WOOL
COTTON
LINEN
fig.9
.
Page 3
Publicidad
