Rowenta DW9020 Manual Del Usuario página 6

DW9020-30-1103905566:FerClassic_BASE_110x220mm
6 • Vertical shot of steam
Hold the iron vertically and press the shot of steam button to remove creases from suits, jackets,
skirts, hanging curtains etc.
IMPORTANT Never direct the steam at persons or animals!
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning
delicate fabrics.
7 • Spray
Press the spray button to dampen difficult creases
8 • Anti-Drip system *
It prevents water escaping from the soleplate when the temperature is too low.
9 • Auto Off function*
• For your safety, the electronic system cuts off the power and the auto off indicator light
flashes fig.12 when:
- The iron remains motionless for more than 8 minutes on its heel.
- The iron remains flat or on its side for more than 30 seconds.
- To restart the iron, just move it gently until the warning light stops flashing.
AFTER USE
10 • Emptying
Unplug the iron. fig.2 Pour away remaining water
Set the temperature control dial
11 • Storing
Allow the appliance to cool down before storing the iron standing on its heel.
IMPORTANT Do not wind the cord around the hot soleplate fig.15.
Never store your iron placed down on the soleplate.
MAINTENANCE AND CLEANING
IMPORTANT Unplug and allow the iron to fully cool down before maintenance and
cleaning.
12 • Anti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits.
This considerably prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and does not need to be
replaced.
13 • Cleaning the iron
When the appliance has cooled down, wipe it down with a damp cloth or sponge, as required.
14 • Self Clean
(prolongs the life of the iron)
IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean the
soleplate and other parts of the iron.
WARNING : Do not use descaling agents even if advertised for steam irons. They will
permanently damage your iron.
The Self Clean function flushes dirt and scale particles out of the steam chamber. Fill the
water tank with untreated tap water up to the max mark and heat the iron to the •••
temperature. Unplug the iron and hold it over a sink horizontally. Push the self clean button
fig.14
for 1 minute : steam will now begin to build up. After a few seconds water will
emerge from the soleplate, rinsing dirt and scale particles out of the steam chamber.
Plug in the iron and allow the iron to heat up again. Wait until the remaining water has
evaporated. Unplug from the mains and allow the iron to fully cool down.
When cool, the soleplate can be wiped with a damp cloth.
TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard,
clean the iron weekly.
(*) Depending on model
(from temperature setting (••) upwards)
fig.10 .
fig.11
fig.13
fig.3 on position Min.
4
3/02/09 17:22
.
.
Page 4