Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 11

3
ATTACHING BOTTOM CORNER BRACKETS
IMPORTANT: Refer to door section identification, located in the pre-installation
section of this manual or refer to Breakdown of Parts.
WARNING
ENSURE TIGHT FIT OF CABLE LOOP OVER MILFORD PIN TO PREVENT
COUNTERBALANCE LIFT CABLE FROM COMING OFF THE PIN, WHICH COULD
ALLOW THE DOOR TO FALL AND RESULT IN DEATH OR SERIOUS INJURY.
IMPORTANT: Verify bottom weather seal
section . If there is more than 1/2" excess weather seal on either side, trim
1
weather seal even with bottom section.
See Figure 11 and Figure 12 for the following steps.
3a. Uncoil the counterbalance lift cables
making sure you place the left hand cable loop
of the bottom corner bracket and the right hand cable loop on the right hand
7
milford pin of the bottom corner bracket.
3b. Position the left hand bottom corner bracket onto the bottom section. Attach
the bottom corner bracket to the bottom section with (3) 1/4" - 20 x 11/16" RED
HEAD self drilling screws . Repeat this process for the opposite side.
8
3c. Insert a short stem track roller
9
brackets.
IMPORTANT: THE 1/4" - 20 x 11/16" RED HEAD SELF DRILLING SCREWS
MUST BE MUST BE INSTALLED THROUGH THE HOLES OF THE BOTTOM CORNER
BRACKETS, AS SHOWN.
4
4
3
5
Figure 11, Left and Right Hand Drums Shown
is aligned with bottom
2
from the cable drum assemblies
3
on the left hand milford pin
5
with roller spacer into the bottom corner
10
4
3
5
3
5
6
,
4
6
9
10
1 Bottom Section
2 Bottom Weather
3 Counterbalance
4 Cable Drum
5
11
3
8
6
5
10
9
Figure 12, Left Side Shown
6
7
Seal
8
Lift Cable
9
Assembly
Cable Loop 10
4
1
7
2
8
Milford Pin
Bottom Corner
Bracket
1/4" - 20 x
11/16" RED
HEAD Self drilling
screws.
Short Stem Track
Roller
Roller Spacer