Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 13

5
ATTACHING STEP PLATES TO SECTION
IMPORTANT: Do not mount the step plate higher than 6"
the section .
2
See Figure 17 for the following steps.
5a. Locate the center most center stile
5b. On the inside of the door , center the step plate
4
no higher than 6" from the bottom of the door.
5c. Using the step plate holes as a template, drill a 5/16" dia. hole
side of the center stile, through the face of the door
IMPORTANT: Be extremely careful to keep drill straight.
5d. Mount the inside step plate and the outside step plate back to back, straddling
the center stile. Secure with (2) 1/4" - 20 x 2-3/4" carriage bolts
20 hex nuts .
9
1
4
2
1
5
8
5
Figure 17
1 6"
2 Bottom Section
3 Center Stile
4 Inside Of The
Door
5 Step Plate
6
ATTACHING LIFT HANDLES TO SECTION
NOTE: Doors with a Keyed lock do not require this lift handle.
See Figure 18 through Figure 20 for the following steps.
6a. Locate the inside center stile or the desired lift handle location
second section of the door. Position the lower hole in the lift handle
2
from the bottom of the second section.
IMPORTANT: The distance between the step plate
handle must be 20" minimum to 30" maximum
upper lift handle to stay within the required dimension.
6b. Using the lift handle holes as a template, drill (2) 9/32" dia. holes
the second section. Enlarge the holes from the outside the door to 1/2" dia
IMPORTANT: Be extremely careful to keep drill straight.
from the bottom of
1
of the bottom section of the door.
3
on the center most stile
5
along each
6
.
7
and 1/4" -
8
7
6
5
8
4
9
6 5/16" Dia. Holes
7 Face Of The Door
8 1/4" - 20 x
2-3/4" Carriage
Bolts
9 1/4" - 20 Hex
Nuts
on the
1
4"
3
and the middle of the lift
5
. If necessary, reposition the
6
through
7
8
IMPORTANT: Do not drill through or enlarge holes on the inside of the door.
6c. Assemble the lift handles to the second section using (2) spacers
- 20 x 2-1/2" carriage bolts
1
8
2
1
7
2
2
1 Inside Center Stile
Or Desired Lift
Handle Location
2 Second Section
3
4
5
6 20" Minimum To
30" Maximum
4
.
13
, and (2) 1/4" - 20 hex nuts
10 11
3
5
6
Figure 18
4
Figure 19
Figure 19
3
6
5
Figure 20
Figure 20
7
8
Lift Handle 9
4" 10
Step Plate 11
, (2) 1/4"
9
.
3
5
9/32" Dia. Holes
1/2" Dia
Spacers
1/4" - 20 x
2-1/2" Carriage
Bolts
1/4" - 20 Hex
Nuts