Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 9

NOTE: The illustrations shown on this page are general representations of the door parts. Each specific door models may have unique variations.
A1. (Quick
Install Feature)
I5.
I3.
I6.
A1.
B1.
H5.
A. FLAG ANGLES:
A1. Quick Install (Q.I.) Flag Angles
B. JAMB BRACKETS (AS REQUIRED):
B1. Quick Install (Q.I.) Jamb Brackets
C. TRACK ROLLERS (AS REQUIRED):
C1. Short Stem Track Rollers
D. GRADUATED END HINGES:
D1. Single Graduated End Hinges (S.E.H.), Industry Standard
E. STACKED SECTIONS:
E1. Top Section
E2. Intermediate(s) Section
E3. Second Section
E4. Bottom Section
F. TOP FIXTURES:
F1. Top Fixture Assemblies
G. STEP PLATES:
G1. Step Plates
BREAKDOWN OF PARTS
I1.
F1.
K1.
H3.
D1.
C1.
G1.
D1.
J1.
H4.
I4.
I5.
I2.
A1.
F1.
E1.
E2.
B1.
D1.
E3.
H6.
E4.
J2.
H1.
Figure 7
H. TRACKS:
H1. Left Hand Horizontal Track
H2. Right Hand Horizontal Track
H3. Left Hand Horizontal Track Angle
H4. Right Hand Horizontal Track Angle
H5. Left Hand Vertical Track
H6. Right Hand Vertical Track
I. TORQUEMASTER PLUS SPRING ASSEMBLY:
®
I1. Center Bracket Bushing Assembly
I2. Spring Tube Assembly (Single Or Double Springs)
I3. Left Hand End Bracket (Double Springs Only)
I4. Right Hand End Bracket
I5. Left Hand And Right Hand Cable Drum Assemblies
I6. Idler bracket (Single Spring Only)
J. BOTTOM CORNER BRACKETS:
J1. Left Hand Bottom Corner Bracket
J2. Right Hand Bottom Corner Bracket
K. LIFT HANDLES
K1. Lift Handles
9
H2.
Top of
vertical
track
B1. (Quick
Install
2nd
Feature)
hole
set
Top hole
1st hole
Middle
set
hole
Bottom
hole