Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 18

4
Figure 33, Right Side Shown
1 Cable Drum
2 Counterbalance
Lift Cable
3 Spring Tube
Assembly
4 Cam Peak
15e. Repeat for left side.
For single spring applications:
See Figure 34 for the following steps.
15f. Insert the idler bracket into the left hand cable drum
1
until two distinct clicks are heard, or the idler bracket is inserted all the way.
IMPORTANT: Ensure the idler bracket snap tabs
cable drum.
NOTICE
THE IDLER BRACKET IS DESIGNED FOR PERMANENT ASSEMBLY. DO NOT AT-
TEMPT TO REMOVE IDLER BRACKET ONCE INSERTED INTO THE CABLE DRUM.
THE IDLER BRACKET MUST BE REPLACED, IF THE SNAP TABS ON THE IDLER
BRACKET BREAK.
IMPORTANT: The idler bracket must extend past the cable drum far enough to
expose the idler bracket groove .
6
15g. Align the idler bracket groove with the round notch
7
6
5
8
5 Winding Shaft
6 Splines
7 Grooves
8 Flag Angle
. Lightly press
3
are fully inserted into the
2
in the flag angle.
4
18
2
1
2
6
1
2
6
2
1
3
Figure 34
1
5
1
Figure 34
1 Idler Bracket
2 Idler Bracket
Snap Tabs
3 Cable Drum
3
1
3
3
4
4 Round Notch
5 Flag Angle
6 Idler Bracket
Groove