Triton TPL180B Instrucciones De Uso Y De Seguridad página 12

Troubleshooting
Symptom
No power
Motor does not start
Rough finish on wood after planing
Depth of cut incorrect
Barrel not rotating
Vibration or abnormal noise
EN
12
982168_OwnerManual.indd 12 982168_OwnerManual.indd 12
Possible Cause
Mains plug not inserted into socket or
switched on
Fuse blown in plug or circuit breaker tripped
in consumer unit
RCD connected and not reset
Extension lead overloaded and thermal
protection has operated
Power lead or power lead connection to tool
or mains plug damaged
Power tool fault
Carbon brushes worn
Power tool fault
Worn blade or blades
Damaged blade or blades
Wood is wet
Worn or damaged blades
Poorly fitted blade or blades
Incorrect blades fitted
Broken drive belt
STOP using tool immediately
Solution
Plug in and switch on
Replace fuse or reset circuit breaker
Reset RCD
Replace extension lead or unwind cable
fully from reel to allow maximum current
use and reset thermal protection
Requires repair at an authorised Triton
service centre
Requires repair at an authorised Triton
service centre
Brushes need replacing by an authorised
Triton service centre
Requires repair at authorised Triton service
centre
Replace all blades
Replace one or more blades
Allow wood to dry
Replace blades
Re-fit blade or blades
Replace blades with correct type
Replace belt
Re-check all user accessible parts are secure
and correctly fitted first and if not solved
contact an authorised Triton service centre
21/11/2022 08:13 21/11/2022 08:13