Publicidad
Idiomas disponibles
Idiomas disponibles
Device configuration with remote control (for iOS)
To configure the device after the first power up or after a factory reset using an iPhone
proceed as follows:
1. While the screen shown is displayed in the figure
on the side, press the keys
NET ON and press the key
(a lack of choice within 30 seconds is equivalent
to choosing NET ON).
2. Make sure the device displays
If not, press the keys
shows
" Conf
nEt"
steady before proceeding with the next point).
3. Start the app, choose "New Thermostat", select the TUO PILA model among
those available and press "Next".
4. Connect to the "iwm..." network generated by the device by following the
instructions on the App. Check that the device display shows the
wait for the
icon to appear on the iPhone display to indicate successful
connection between the app and the device.
5. Now enter the complete name of the Wi-Fi network where connect the device and
enter the password, be careful to digit faithfully all characters (uppercase,
lowercase, spaces, digits) that compose them. Confirm to continue.
Important: before proceeding make sure that the
is still on. Otherwise, access the Wi-Fi settings of the smartphone to manually
reconnect to the "iwm ..." network
6. The device restarts: wait for the
icon to start flashing.
7. Enter a name that identifies the Tuo Wi-Fi PILA, and choose an icon to help to
identify the device from those proposed and confirm.
8. The configuration procedure is finished. Now:
the app displays the list of devices associated with your account among which also
the newly associated device must appear..
The Tuo Wi-Fi PILA displays the main screen. Check that the icon
and the time shown at the top left is correct.
NOTE: If the configuration is not successful, the message "Err" followed by a number
may appear on the device display. Repeat the configuration procedure be careful to
digit faithfully all characters (uppercase, lowercase, spaces, digits).
and
to choose
to confirm
" Conf
nEt"
and
simultaneously for a long time until the display
and the
icon starts flashing (wait for it to become
icon on the device to become steady and the
- 49 -
OB327000 Chronothermostat User Manual
.
icon and
icon on the device display
is steady
Publicidad
