Normatec 3 Instrucciones Originales página 7

Normatec 3 Hip Attachment (single-person use only)
2
1
Normatec 3 Charger
1
OPERATING INSTRUCTIONS
WARNING! BEFORE OPERATING THIS SYSTEM: Read all warnings at the beginning
of this manual. If you do not understand these operating instructions, contact Hyperice at
+1.949.565.4994.
SET UP THE SYSTEM
• Step 1: Plug the charger into an electrical outlet and then into the Normatec 3 control
unit.
This control unit is equipped with a lithium ion battery. The battery automatically
charges when the charger is connected to the Normatec 3 control unit and an
electrical outlet.
• Step 2: Connect the hose connector to the air outlet on the Normatec 3 control unit.
The connector can only be inserted in the correct orientation. Insert the connector
firmly into the Normatec 3 control unit until you hear an audible "click."
• Step 3: Put the leg, arm, or hip attachments on. Find a comfortable position sitting,
reclined, or lying down. If the attachments have a zipper, be sure to zip up the
attachments completely. Never try to use the system with the zipper partially or totally
unzipped—this could void your warranty. Only one set of attachments can be used
with a single control unit. When using more than one attachment, make sure they are
both of the same type.
• Step 4: Connect the attachment connectors on each attachment to the junction box
air outlets. The attachment connectors can only be connected to the junction box in
the correct orientation. Insert the attachment connectors firmly into the junction box
air outlets until you hear an audible "click."
If only one attachment will be connected to the junction box, use the blocking plug
located on the underside of the junction box to block off the unused junction box air
outlet. Press firmly to make sure the blocking plug is fully seated.
• Step 5: Press the power button on the Normatec 3 control unit firmly for one second
to turn on the system. While the control unit is on, the green LED next to the power
button will be lit up.
SELECT YOUR ATTACHMENT
To set the device to run the appropriate treatment for the attachment you are using, press the
Attachment Selection button to select either Legs, Hips, or Arms. When Hips are selected the
device will automatically run a two-zone treatment to match the number of zones on the Hips.
3
2
1
2
1 - 2. Zones
3. Attachment connectors
1. Wall outlet plug
2. Barrel connector