Silvercrest SEM 1100 C4 Instrucciones De Uso página 19

Drawing hot water
You can also use the milk frother 0 to draw hot water; for example, to dilute
a coffee (café americano) or prepare tea.
1) Switch the appliance on using the On/Off switch 1. The operating lamp z
lights up. The "Espresso" control lamp t flashes. Make sure that the steam
control 7 is turned in the direction of the "▯" as far as the stop.
Wait until the pointer of the temperature indicator 2 is approximately half
way between 80°C and "
continuously.
2) Hold a heat-resistant container under the milk frother 0.
3) Turn the steam control 7 at least half way towards "
4) Press the "Espresso" button
frother 0.
5) Press the "Espresso" button
6) Close the steam control 7 (turn it as far as it will go in the direction of the "▯"
symbol).
Cleaning and care
WARNING! RISK OF INJURY!
► Always remove the plug from the mains power socket before you clean the
appliance. Risk of electric shock!
► Always allow the appliance to cool down before cleaning it. Risk of burns!
Never immerse the appliance in water or other liquids! Risk of electric
shock!
CAUTION! PROPERTY DAMAGE!
► To avoid damage, never use abrasive, aggressive or chemical cleaning
agents to clean the surfaces of the appliance.
Cleaning the milk frother
1) Place an empty container under the milk frother 0.
2) Immediately after use, turn the steam control 7 to the "
and allow the steam to escape for a few seconds.
3) Turn the steam control 7 off (as far as it will go in the direction "▯"), switch
the appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Pull the casing of the milk frother 0 off (Figure 1) and clean it thoroughly in
warm water.
■ 16 │ GB │ IE
" and the "Espresso" control lamp t lights up
3. Hot water will come out of the milk
3 again to stop the flow of hot water.
".
" position
SEM 1100 C4