Stihl GHE 105.0 Manual De Instrucciones página 42

17. Technical specifications
GHE 105.0
Power 2200 W
Amperage rating 9.8 A
Rated voltage 230 V
Frequency 50 Hz
Speed 2800 rpm
Mains fuse 16 A*
Protection class I
Type of protection Splash proof
(IPX4)
Operating conditions P40
40 s load time
60 s idle time
Tightening torque 25 Nm
Blade disc
screw
Tightening torque 10 Nm
Reversible blade
screw
L/W/H 77/48/97 cm
Weight 19 kg
19 kg (CH)
20 kg (GB)
40
Sound emissions:
In accordance with 2000/14/EC / S.I.
2001/1701:
Guaranteed sound
power level L 104 dB(A)
WAd
Uncertainty K 3 dB(A)
WA
In accordance with EN 50434:
Sound pressure level
at workplace L 93 dB(A)
pA
Uncertainty K 3 dB(A)
pA
* Attention!
Mains fuses of less than 16 A may
frequently trip during start-up of the
machine or when it is operating under
heavy load.
17.1 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
18. Troubleshooting
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
– Check power cable and fuse
( 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) ( 10.1)
– Replace fuse
– Close feed chute properly and tighten
screws ( 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
( 11.2)
– Reset locking device (
Fault:
Frequently tripped mains fuse
Possible cause:
– Unsuitable electric cable
– Power overload
– Machine overloaded
Remedy:
– Use suitable electric cable (
– Connect the machine to another circuit
– Reduce quantity of shredding material;
reverse, re-sharpen or replace the
shredding blades (
0478 201 9915 C - EN
8.6)
11.4)
10.1)
11.5)