Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
When cleaning the inside of the firebox hood and grill bottom,
use a strong solution of detergent and water with a scrub
brush to clean. Rinse thoroughly and allow to air dry. NEVER
use a caustic grill cleaner on painted or cooking surfaces.
All plastic parts, stainless-steel and painted surfaces, should
be cleaned with warm soapy water and wiped dry. Cooking
surfaces should be cleaned with a bristle brush only. Check
that no loose bristles remain on the cooking grates prior to
using.
Cooking grates:
Clean before and after each use with a stiff wire brush.
Port shields:
Scrape any build-up off the port shields using a wire
brush.
Grease:
After use, allow the grease in the cup to cool then empty
into the garbage.
Empty after each use to avoid spillage and flare ups.
CLEANING BURNER ASSEMBLY AND
CHECKING VENTURI FOR INSECTS
See Figures 21 - 22.
DANGER:
Failure to clean the burner assembly and check the
venturi as described can result in a fire or explosion
resulting in serious injury or death.
Burner should be cleaned when the grill has been idle
for some time. In some parts of the country, spiders and
other insects can spin webs, build nests, and lay eggs in
the venturi blocking gas flow and causing fire in the tubes
known as "flashback". Flashback can damage the grill and
even cause injury.
Turn control knob to OFF ( O ). Allow grill to cool completely.
NOTE: To lock the control knob in the off position, turn
the control knob to LOCK (
Remove the LP gas cylinder.
Pull electrode wire from the electronic ignitor.
Remove the wing nuts securing the burner to the firebox.
Using work gloves, lift burner up and away from the gas
valve openings.
MAINTENANCE
).
16 — English
PORT SHIELD
BURNER
FIREBOX
ELECTRODE
WING
NUT
Fig. 21
Clean burner tubes using one of the following three ways:
1. Bend a stiff wire into a small hook. Run the hook
through the burner tube several times.
2. Use a narrow bottle brush with flexible handle and
run through burner tubes several times. DO NOT
use a wire brush.
3. Wear eye protection then use an air hose to force
air into the burner tube and out through the burner
port. Clean any clogged port with an opened paper
clip.
Fig. 22
GAS VALVE
ORIFICE
BURNER
TUBE
Publicidad
