Darning - Janome 7360 Manual De Instrucciones

Darning

Machine setting
q Pattern
w LED display
e Foot
R: Automatic buttonhole foot
z Pull the button holder fully to the back.
x Draw the needle thread to the left through the hole
on the foot.
c Lower the needle into the fabric where start to sew.
Lower the foot and depress the foot control.
The machine will darn and stop automatically. The
LED display will show a blinking dot when the
darning is finished.
NOTE:
The maximum length and width of the darning are
2 cm and 0.7cm respectively.
Sew another layer of darning over the previous one, at
the right angle.
q Button holder
w Starting point
e Maximum length (2cm)
r Maximum width (0.7cm)
t Blinking dot
a a a a a To sew a shorter darning
Sew the first row to the required length and press
the reverse stitch button. Continue to sew the
remaining stitches until the machine stops
automatically.
y Reverse stitch button
u Required length
s s s s s Adjusting the evenness of the darning
(A) If the left corner is lower than the right side,
press the Up (+) key to correct it.
(B) If the right corner is lower than the left side,
press the Down (–) key to correct it.
NOTE:
Allowable adjustment range is d1-d9.
Default setting is "d5".
q
z x c
q
w
t
a a a a a
y
s s s s s
(A)
56
w e
e
v
u
r
(B)