Publicidad
Idiomas disponibles
Idiomas disponibles
B
Warning
13
indicator
WATER SOFTENER
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in salt consumption.
1.
Close the door, switch on the appliance;
2.
Within 60 seconds after the appliance was switched on press the Program button ">"
for more than 5 seconds to enter the water softener setting mode, the salt indicator
blinks as 1Hz frequency.
3.
Press the Program button again to select the proper set according to your local
environment, the setting will change in the following sequence: H3->H4->H5->H6-
>H1->H2->H3;
4.
Without operation in 5 seconds or press the Power button to complete the setup and
exit the setting mode.
Using the appliance
Water Faucet
If the "
reaching the dishwasher.
Rinse Aid
If the "
low on dishwasher rinse aid and requires a refill.
Salt
If the "
low on dishwasher salt and needs to be refilled.
22
" indicator is lit, it means that no water is
" indicator is lit, it means the dishwasher is
" indicator is lit, it means the dishwasher is
EN
Publicidad
