pellenc EXCELION ALPHA Manual De Instrucciones página 76

7. INCIDENTS AND TROUBLESHOOTING
7.1. TABLE OF INCIDENTS AND BREAKDOWNS - TROUBLESHOOTING
LED status
Incident /
breakdown of the battery
0
The tool
does not start
I
The cutting
head makes
an abnormal I
noise or vi-
brates a lot
76
GRASS STRIMMER EXCELION ALPHA
53_144013_C
Probable cause
of the tool
handle
Off Battery is off
Battery
Off
Electronic cir-
cuit board
Trigger no
longer functions
On
Electronic cir-
cuit board
Damaged
cutting head
Motor shaft
damaged
Strimmer wire
not cut to length
On
Strimmer
wire too long
Strimmer wire
badly wound in
the cutting head
Checks Solutions
Press the
Battery switch button on
the battery
Check that the bat-
Recharge
tery is not com-
the battery
pletely discharged
At an autho-
Change the
rised PEL-
circuit board
LENC distributor
At an autho- Change
rised PEL- the trigger
LENC distributor or sensor
At an autho-
Change the
rised PEL-
circuit board
LENC distributor
Check there is Change the
no deformation cutting head
Check the condi-
Change the
tion of the shaft
motor shaft
(no distortion)
See Sec-
tion 5.6, "Ad-
Check that you
justing the
are in speed 3
length of the
strimmer wire"
Check that the Refit the
wire cutting strimmer wire
plate is fitted cutter plate
Fit the pro-
tective cas-
Check that the ing see Sec-
protective cas- tion 4.2.1,
ing is fitted "Fitting
the protec-
tive guard"
Check the wind- See Sec-
ing of the strim- tion 6.5.2,
mer wire in the "Fitting the
cutting head. strimmer wire"
Repairer
User
User
Pellenc au-
thorised
distributor
PELLENC
authorised
distributor
Authorised
PELLENC
distributor
User
Pellenc au-
thorised
distributor
Authorised
PELLENC
distributor
User
User
User
User